How to crimp micro connectors Benedikt Haak January 24, 2017 15:34 Follow If you are serious about custom micro builds, you MUST have a PA-09. Have more questions? Submit a request Comments Adam Madron June 19, 2015 15:50 Thanks Benedikt! I see you are continually at work here. Have had the experience of trying to do this without the crimpers! Them molex crimpers, holy cow 300$+. I purchased the same ones used in the video here for about 35$. Folks were ambiguous in the reviews equal amount of bad and good but in reading the good most note that you have to use a certain amount of finesse when crimping with these or you will sever the wire or just not get good results.Another skill learned ;) So much more than just a video on crimping. Adam Madron June 19, 2015 16:43 Here is a link for the official connector thread from fpvlab if anyone needs to source the plugs and sockets for anything rc pretty much. http://fpvlab.com/forums/showthread.php?8921-Official-Connector-Thread Adam Madron June 19, 2015 17:12 Even better here is a link to kits for the molex pico blades http://www.molexkits.com/Type/PicoBlade/ They are fairly expensive as compared to sourcing each individual part separately but convenient that they have assorted kits with all the necessary components.